3 A normal temperature water, using ordinary portland cement foam technology the cement foam equipment technology transfer company I recently successfully developed, it not only changed the technical problems of the traditional use of warm water to foam, and can make the hair bubble-finished cement products within 20 minutes of the initial set of stripping, cutting two hours. Has the following advantages: l, using this kind of technology, the production process is simple, easy to control. Most manufacturers faced production instability problems, the foam height can not control cell sizes, difficult to lower the density, the strength is difficult to protect, do not increase the production efficiency and so on. 2, using this kind of technology, you can shorten the mixing time, easy-uniform slurry, foam stability, to prevent foaming process collapse, cracking phenomenon. 3, using this kind of technology, the use of water at room temperature, can be simple foam. 4, using this kind of technology, not London sulphoaluminate cement or ordinary Portland cement foam, all can choose to use water at room temperature can be foamed, and from the the the cement the overall chemical foaming reaction after 20 minutes to reach early condensate, 2 hours Stripping cutting, supporting our manufacturing automated production lines, can fully realize the line cutting. 5, using this kind of technology, not Lun ordinary portland cement or sulfur aluminate cement foam, mold can be stationary or track mobile, does not affect the foaming effect, uniform cell wall smooth shiny hole. 6, using this kind of technology, you can make the foam cement foam over 1 m in height, tower mode phenomenon will definitely not happen. 7, using this kind of technology, the adaptability of different varieties around the cement with fly ash, low density can be achieved. Contact; Manager Liu Tel: 15383062300